[SOLVED] Wine, Midi devices and KXStudio Welcome

Post fully complete "how to" guides and tutorials here. This is a great place to get feedback on stuff you might put in the wiki.

Moderators: MattKingUSA, khz

Post Reply
FGPkeys
Established Member
Posts: 3
Joined: Sun Jul 07, 2013 8:00 pm

[SOLVED] Wine, Midi devices and KXStudio Welcome

Post by FGPkeys »

Hello friends.
I commented on a problem I had:
After running "KXStudio Welcome", all software running from Wine does not recognize the MIDI hardware (MIDI and USB).
"Jack_midi - port" "a2jmidid - port" and "Midi Through Port - (0 to 13)" were the visible options. In my particular case, it was impossible for me to use the editor for my Korg RADIAS. I tried all possible connections from these ports to my hardware, but it did not work.
I found the solution by stopping Jack from Cadence, then running the command "sudo rmmod snd_seq_dummy", "Force Restart" Cadence's button, then there Wine can properly recognize the hardware.
Can this be solved in upcoming versions of "KXStudio Welcome"?
Thank you!
Last edited by FGPkeys on Sat Apr 29, 2017 4:54 pm, edited 1 time in total.
FGPkeys
Established Member
Posts: 3
Joined: Sun Jul 07, 2013 8:00 pm

Re: Wine, Midi devices and KXStudio Welcome

Post by FGPkeys »

falkTX wrote:it's not cause by that, but rather a config file in kxstudio-default-settings

Edit /etc/modprobe.d/snd-seq-dummy_16.conf and lower the number of ports (say to 2), then reboot.

The problem is some applications not being able to recognize so "many" midi devices at once.
See if that works
Right!
You have solved the problem.
Thanks, falkTX :D
Post Reply