Hello folks.
I'm trying to setup my guitar with Behringer UM2 device, working under Linux Mint. UM2 works fine. But I just can't figure out how to connect all links together. Guitar is connected properly. When a pick the strings the "Sig" indicator on UM2 turns green.
When I open QJackctl setup, under "Interface" menu I have following interface options: "HDA Intel PCH (hw:0)", "Generic analog (hw:0,0)", "USB Audio codec (hw:1)" and "USB Audio (hw:1, 0)"
These are connections, when I start Jack:
And these are when I start Guitarix:
From this point I can't figure out what to do. I tried some additional connections, but I either get no sound, or some noise but not from headphones connected to UM2 but from laptop's speakers.
Behringer UM2, Guitarix and Jack
Moderators: MattKingUSA, khz
-
- Established Member
- Posts: 194
- Joined: Mon Nov 13, 2017 5:54 am
- Has thanked: 8 times
- Been thanked: 4 times
Re: Behringer UM2, Guitarix and Jack
Hi,
if you have set up your soundcard correctly, the needed connections are:
System Capture 1 - gx Head in
gx Head FX 0 and 1 to system Playback 1 and 2
Guitarix also have an auto-connect feature which usually does the right thing when playing guitar solo.
if you have set up your soundcard correctly, the needed connections are:
System Capture 1 - gx Head in
gx Head FX 0 and 1 to system Playback 1 and 2
Guitarix also have an auto-connect feature which usually does the right thing when playing guitar solo.
-
- Posts: 2
- Joined: Thu May 09, 2019 4:20 pm
Re: Behringer UM2, Guitarix and Jack
Thank you. That setup worked.Musicteacher wrote:Hi,
if you have set up your soundcard correctly, the needed connections are:
System Capture 1 - gx Head in
gx Head FX 0 and 1 to system Playback 1 and 2
Guitarix also have an auto-connect feature which usually does the right thing when playing guitar solo.