Qtractor - automate modwheel and pitchwheel

Support & discussion regarding DAWs and MIDI sequencers.

Moderators: MattKingUSA, khz

Post Reply
thebutant
Established Member
Posts: 169
Joined: Sun Nov 18, 2012 12:59 pm
Has thanked: 50 times
Been thanked: 8 times

Qtractor - automate modwheel and pitchwheel

Post by thebutant »

I feel a bit stupid for asking about this, as I think there's some basic knowledge that I've missed out on.
But is there a way to automate modwheel and pitchwheel in Qtractor?

Most synths (well, all the ones I've checked) don't have these two as automation parameters.
And I've noticed that if I record with a midi keyboard, the pitchwheel bending is saved in the midi recording.
But I don't know how to change modwheel and pitchwheel later or how to automate them without having to record it live.
Is there a way?
Harry_Krishnerd
Established Member
Posts: 18
Joined: Sat Dec 23, 2017 1:14 am
Has thanked: 1 time
Been thanked: 1 time

Re: Qtractor - automate modwheel and pitchwheel

Post by Harry_Krishnerd »

Open your clip in the editor and change the values in the type & parameter tabs.

ie, for the mod wheel: {Note On} {Cotroller} {1 Mod wheel}
thebutant
Established Member
Posts: 169
Joined: Sun Nov 18, 2012 12:59 pm
Has thanked: 50 times
Been thanked: 8 times

Re: Qtractor - automate modwheel and pitchwheel

Post by thebutant »

Ah, thanks!
That's very helpful. :)
Post Reply