Search found 5 matches
- Thu Aug 22, 2019 11:28 pm
- Forum: System Tuning and Configuration
- Topic: [DELETED]
- Replies: 2
- Views: 1710
Re: A decent sound card seems to eliminate pops and clicks in the bridge between ALSA and JACK.
if you're doing streaming and want to shorten latencies over the network card, there's kernel parameters such as (to be used in sysctl.d settings) net.core.busy_poll = 1 net.core.busy_read = 1 net.core.netdev_budget_usecs = 10000 net.ipv4.tcp_low_latency = 1 if you're doing this-> "IRQ_FORCED_T...
- Thu Aug 22, 2019 10:13 pm
- Forum: System Tuning and Configuration
- Topic: alsa/USB problem.
- Replies: 2
- Views: 1966
Re: alsa/USB problem.
according to other users online, this usb audio device could work -- note: it's an old thread of 2015, so by now if that card got into the interest of development it should be in a better state, but by the looks of your dmesg output, it looks like there's too many disconnects, suggesting that it is ...
- Thu Aug 22, 2019 9:31 pm
- Forum: System Tuning and Configuration
- Topic: Difference between jackd and jackdbus
- Replies: 18
- Views: 21881
Re: Difference between jackd and jackdbus
actually if "jackdbus" is NOT running, and you use "jack_control", it will dbus-activate jackdbus. I found out a way to prevent this (posted a new topic in this forum) if a user doesn't want this. Eg, suppose you want "jackd" only and do not want to use jackdbus, then a...
- Thu Aug 22, 2019 9:25 pm
- Forum: System Tuning and Configuration
- Topic: Jackd+A2J with Systemd startup
- Replies: 1
- Views: 1522
Re: Jackd+A2J with Systemd startup
Amended these changes for the service unit files, as well as implementing "SystemdService=" in the dbus files meant I had to remove "Exec=" from these units. ~/.config/systemd/user/dbus-org.jackaudio.service " [Unit] Description=JACK 2 After=pulseaudio.service Requires=dbus....
- Thu Aug 22, 2019 2:14 am
- Forum: System Tuning and Configuration
- Topic: Jackd+A2J with Systemd startup
- Replies: 1
- Views: 1522
Jackd+A2J with Systemd startup
I finally managed to get a working startup with systemd. The setup: 1 alsa card Load pulseaudio , followed by JackdBus+A2jDbus (for those who are familiar there's "a2jmidid -e" which doesn't run in dbus mode) The Pros: - You can start JackdBus on and off without conflicting with Pulseaudio...